Spark plug wire and terminals for DIY

Spark plug wire with high conductivity, sold by the meter.

Pliers for tightening the spark plug cable terminals thus allowing you to self-build and tighten the spark plug cable terminal connectors in complete autonomy, carrying out a workmanlike job.

Hood and its terminal at 90 degrees for mounting on a reel for mounting with claws.

Cap and relative straight terminal for connection to cap or coil to build your own spark plug cables

Hood and corresponding female terminal at 90 degrees to the coil or spark plug.

Hood and corresponding female terminal to 90 degrees.

Hood and its terminal straight clip-on candle, a maximum length of 8 cm.

Hood and its male terminal 90 °

Spark plug wire PROTOXIDE high conductivity sold by the meter.

The kit consists of spark plug terminals and silicone pipettes for insulating 4 90° spark plug plugs and 4 90° male coil plugs complete with specific terminals

The kit consists of 4 90° spark plug plugs and 6 90° coil distributor plugs with male terminal.

Plug straight plug with suitable terminal to be crimped on cable 8.5mm or 8.8mm.

Hood and its male end 90 with restricted head for

90 degree terminal and pipette for coupling on distributor or coils.

High conductivity spark plug wires made to measure for 4-cylinder engines with an external diameter of 8.8mm. Generic photo

Single candle cable already crimped from one end with the long candle plug as shown in the picture.

Plastic clips that allow you to space out and stop the spark plug wires

Plug plug straight plug with metal terminal suitable to be crimped on 8.5 or 8.8mm cable.