Fittings and pipes kit Fiat Grande Punto - 500 Abarth with GT1548 turbo

Oil restrictor fitting made as indicated by Garrett for all Garrett GT - GTX series turbochargers on bearings, Gt25, Gt28, Gt30, Gt35, GTO, GTX 1 and 2 generation

Stainless steel fitting for all the turbochargers Garrett T3 - T4 - T5

This oil pipe allows you to install the new line to create the oil delivery for the turbocharger on ALL FIRE engines transformed into turbo suitable to be connected to whatever position the turbo is connected (high, central, low position)./ p>

Hollow screw for TD04 turbocharger without any internal filter

1/8 T-joint and two 8mm hose connectors, very useful for connecting a pressure gauge to measure the fuel pressure before the fuel rail or the pressure regulator.

Aluminum spacer for Mitsubishi TD04 Turbocharger oil drain which allows you to use the shorter original pipe and thus lengthen it to the right length.

Aluminum cap that allows you to close the water passage on all Abarth 500 Grande Punto T-Jet engines when installing a turbocharger that does not have water cooling such as the TD04 turbo and the thermostat or water pipe

Oil delivery pipe for Garrett GBC17 - GBC20 - GBC22 turbocharger to be installed on all cars of the Fiat Alfa Lancia group such as Mito Giulietta 500 Abarth etc.

Fittings difficult for absolute traceability cooling water hose with shorts for turbochargers

Hollow screw for pipe with banjo eye for oil outlet on original Fiat Uno Turbo and Fiat Punto gt engine block with 10mm eye and delivery pipe for turbocharger.

Oil pipe that allows you to install any Garrett turbocharger on double bearings from the ProtoXide Gto 23 wings Garrett G25-G28-GT30-Gt35 and GTX28-GTX30-GTX35 turbochargers and ProtoXide Gto turbocharger with lateral position above the gearbox side.

This tube is dedicated to the oil passage allows to install the original IHI turbocharger.

Aluminum oil drain fitting complete with relative specific gasket and bolts usable on all Garrett GT series turbochargers on bushings such as 1446 (it is necessary to change the bolts) and on bearings, Garrett GTX , Gt25, gt28, gt30, gt35 and GBC turbochargers, Mitsubishi TD04 and many other turbocharger models

Turbocharger delivery oil pipe that allows you to install any Garrett turbocharger on double bearings from GT25- GT28 -GTX 28 - GT30 - GTX30 any generation and ProtoXide Gto23 turbochargers and all turbochargers on Garrett bearings.

AN10 20X1.5 male nipple fitting in magnetic galvanized steel, it can be fixed as a simple screw-on nipple.

This tube allows for any oil Garrett turbocharger on double bearings.