12x1.5 drilled screw for the turbocharger oil inlet without filter

Shaped tube difficult for absolute traceability cooling water hose for turbocharger

1/8 T-joint and two 8mm hose connectors, very useful for connecting a pressure gauge to measure the fuel pressure before the fuel rail or the pressure regulator.

Oil hose allows you to install the new line to create the oil delivery for the turbocharger on ALL Minicooper R50 engines transformed into turbo, suitable for connection to any position the turbo is connected (high, central, low position).

This kit provides the dedicated fittings, gaskets and tubing necessary to mount the Garrett GT1446 turbocharger.

Pair of fittings that are difficult to find for water cooling with Lughi hose connector for turbocharger

Oil delivery pipe for Lancia Delta 1600 Turbo which allows the installation of the original turbocharger.

Aluminum spacer for oil drain of Garrett GT - GTX - GBC Mitsubishi TD04 turbochargers which allows you to use the shorter original pipe and thus lengthen it to the right length.

Stainless steel oil drain fitting for Garrett GT - GTX and Mitsubishi TD04 turbochargers and many other turbochargers. Unobtainable

Drilled hollow screw for oil inlet delivery of Garrett GBC 14-200 17-250 20-300 88-350 turbocharger without any internal filter.

Hollow screw for TD04 turbocharger without any internal filter

This kit provides all the dedicated fittings, gaskets and all the pipes necessary for the assembly of the IHI IS38 turbochargers with heart on Garrett GT and GTX bearings.

Oil delivery hose to replace the original Fiat 500 Panda 1300 Mjet 2wd and 4x4 and similar engines made of a new reinforced PTFE hose covered in metal braid.

Mitsubishi TD04 aluminum oil drain fitting with relative specific gasket that can be used on all turbochargers.

Fiat 500 Abarth oil drain pipe for engines with an oil radiator installed, without the water-oil exchanger. This pipe allows you to connect the turbocharger oil drain with the return to the engine crankcase in the sump in a professional, clean and definitive way.

stainless steel fitting for all turbochargers Garrett GT series of bearings, GT25, GT28, GT30, GT35 and Mitsubishi TD015-TD02- TD03- TD04- TD06 and TD05-KKK K03-K04. Complete with its seal.

Renault 5 Gt Turbo 1st series 4AN turbocharger fitting