Drilled screw for turbocharger oil inlet TD04 WITHOUT FILTER

Oil delivery pipe for FIAT PUNTO GT - UNO TURBO 1600 to install any Garrett - XONA turbocharger on double bearings GT 23 GT25, GT28, GT30, GT35, GTX28 GTO, G25, GT23 above the side gearbox.

Stainless steel fitting for all the turbochargers Garrett T3 - T4 - T5

Turbocharger delivery oil pipe that allows you to install any Garrett turbocharger on double bearings from GT25- GT28 -GTX 28 - GT30 - GTX30 any generation and ProtoXide Gto23 turbochargers and all turbochargers on Garrett bearings.

Oil delivery pipe for Lancia Delta, Fiat Coupè, with any engine from 1600 to 2000 both 8 and 16v and allows the installation of any type of Mitsubishi TD05 turbocharger derived from Mitsubishi Evo 8-9 with turbo position on the manifold similar to the original one .

Oil delivery pipe for FIAT PUNTO GT - UNO TURBO 1400 to install any Garrett - XONA turbocharger on double bearings GT 23 GT25, GT28, GT30, GT35, GTX28 GTO, G25, GT23 above the side gearbox.

1/8 T-joint and two 8mm hose connectors, very useful for connecting a pressure gauge to measure the fuel pressure before the fuel rail or the pressure regulator.

stainless steel fitting for all turbochargers Garrett GT series of bearings, GT25, GT28, GT30, GT35 and Mitsubishi TD015-TD02- TD03- TD04- TD06 and TD05-KKK K03-K04. Complete with its seal.

Aluminum cap that allows you to close the water passage on all Abarth 500 Grande Punto T-Jet engines when installing a turbocharger that does not have water cooling such as the TD04 turbo and the thermostat or water pipe

This oil pipe allows you to install the original Garrett turbocharger without any modification

Shaped tube difficult for absolute traceability cooling water hose for turbocharger

stainless steel extension for joining together two pipes.

hard to find fittings for water cooling with short hose for turbocharger

Nipple fitting AN10 in stainless steel, it can be welded or fixed as a simple nipple to be screwed on or to be used for welding on the oil return to the sump.

1/8 T-joint and two 8mm hose connectors, very useful for connecting a pressure gauge to measure the fuel pressure before the fuel rail or the pressure regulator.

This kit provides the dedicated fittings, gaskets and tubing needed to fit any Garrett bearing-bearing turbocharger such as the GT28, GTX28 and GTO ProtoXide.