Pressure sensor -1bar to 3bar turbo power supply 12 volts signal output 0-5v mod.1

Turbo pressure sensor with working range up to 3 bar turbo and 4 bar absolute for TFSI TSI 2.0 and 2.5 5-cylinder engines and in any case all cars of the Volkswagen Audi group 4-wire connector.

Increased pressure sensor for Smart capable of reading up to 2.1 bar, usable on almost all turbo petrol and turbo diesel engines and allows the engine warning light to not come on if appropriately remapped.

Map or Aps sensor absolute pressure sensor up to 3.5 bar with Bosch male connector with 12 volt power supply and 5 volt signal output

The pressure sensor installed on 06/01 fiat coupe 16v has the limit of arriving to measure the turbo pressure up to a maximum of 1.5 bar. Our fully plug and play sensor will be able to reach up to 2.2 bar

Turbo pressure sensor with working range requested by the customer.

Linear pressure sensor up to 10 bar with 0-5 volt output that can be used to measure the pressure of gasoline, oil, air and other liquids. 5 volt power supply

Smart Brabus 900 turbo engine pressure sensors that allow you to measure higher pressures up to 3 bar ideal for all vehicles that need an increase in power and have original sensors that do not allow correct turbo management.

Pressure sensor with turbo working range from -1 bar up to +3 bar. GM-type connector

Increased pressure sensor up to 4 Bar absolute and can be used on any control unit that accepts a 0-5 volt input signal, especially on Turbodiesel engines but also on petrol turbos when you want to avoid the engine failure warning light and at the same time increase the turbo pressure .

Increased pressure sensor up to 4 Bar absolute and can be used on any control unit that accepts a 0-5 volt input signal, especially on Turbodiesel engines but also on petrol turbos when you want to avoid the engine failure warning light and at the same time increase the turbo pressure . 3 WIRE connection

Map or Aps pressure sensor absolute pressure sensor up to 3bar with 12 volt power supply and 0-5 volt signal

Linear pressure sensor up to 100 bar with 0-5 volt signal output can be used to measure the pressure of petrol, oils, air, nitrous oxide and other liquids. Power supply from 12 to 30 volts.