The FERMO APS module allows you to deceive the original control unit by hiding the real maximum TURBO pressure or any pressure peaks, which form in the intake duct and which consequently generate the annoying power cut and consequent warning light with engine failure due to exceeded overpressure, so with this module it is possible to avoid this.
Linear pressure sensor up to 110 bar with 0-5 volt signal output which can be used to measure the pressure of petrol, oils, air, nitrous oxide and other liquids. Very convenient power supply as it is possible to connect it to a power supply between 5 and 16 volts.
Increased pressure sensor up to 3.5 Bar absolute and can be used on any control unit that accepts a 0-5 volt input signal, especially on Turbodiesel engines but also on petrol turbos when you want to avoid the engine failure warning light and at the same time increase the turbo pressure .
Support that allows you to space the filter and immediately have 3 holes ready to apply the oil pressure temperature sensors or delivery pipe for application of the oil delivery pipe for turbocharger or for aspirated engines.
Increased pressure sensor for Smart capable of reading up to 2.1 bar, usable on almost all turbo petrol and turbo diesel engines and allows the engine warning light to not come on if appropriately remapped.
Smart Brabus 900 turbo engine pressure sensors that allow you to measure higher pressures up to 3 bar ideal for all vehicles that need an increase in power and have original sensors that do not allow correct turbo management.