- Online only

Tel +390585026777
This unit Plug and Play for Mitsubishi Lancer EVO 8 allows it to be replaced to the original, as it has the usual method of attack.
SECURE ENCRYPTED PAYMENTS
TRACKING NUMBER FOR ALL ORDERS
MON-FRIDAY SUPPORT 10.00-12.30 15.00-17.30
Name | Value |
---|
HAYABUSA engine control unit transformed into Turbo 1300 with dedicated wiring and CDI IGNITION with original tone wheel sensors, rpm sensor and phase sensor all as standard, no modifications to be made.
This control unit allows to set a threshold from 0-5 volts that when exceeding a selected voltage activates a relay such as the prot oxide relay or any other activation
Serial Cable - Jack used to connect with all the Autronic ECUs
This unit allows you to turn a car into a turbo intake or carburetor injection or to take the place of your original unit for a complete engine management and dashboard.
Questa scheda permette di essere alimentata 0-12v e di far uscire un segnale 0-5v proporzionale a 0-1000 C? connettendola alla nostra sonda K di precisione .
"Plug and Play" programmable competition control unit for Ford Sierra Cosworth 2000 Turbo engine replaces the original IAW Marelli.
programmable control unit can be installed from the competition of Fiat or Fiat Uno Turbo complete wiring Punto Gt
Competition programmable ECU that can be installed on Lancia Delta 2000 16v Turbo
This unit Plug and Play for Mitsubishi Lancer EVO 9 allows it to be replaced to the original, as it has the usual method of attack.
Interface which can drive an electric engine throttle "drive by wire"
This unit allows it to be for 1995-1996 Subaru replaced the original, but is necessaro connect it to the original comb.
Interface that allows you to send a Canbus signal to manage some modules which would not work without a signal
This unit Plug and Play for Mitsubishi Lancer EVO 4 allows it to be replaced to the original, as it has the usual method of attack.
This unit Plug and Play for 2001-2005 Subaru allows it to be replaced to the original, as it has the usual method of attack.
This CDI Ignition control unit allows you to completely manage the ignition advance on 4 to 8 cylinder engines with a single distributor based on the engine load, therefore suitable for both naturally aspirated and turbo engines. It has rev limiter and Launch Controller or start limiter fully programmable by software. It is also possible to eliminate the pins and even in some cases permanently eliminate the distributor.
4-output power amplifier module for electronic control units.
This unit Plug and Play for Mitsubishi Lancer EVO 8 allows it to be replaced to the original, as it has the usual method of attack.