Kit Flywheel steel + copper + clutch pressure plate Fiat Punto GT

Single-mass aluminum flywheel with reinforced pressure plate clutch unit.

Kit with flywheel mass in special steel mono-made to accommodate a specific disk with springs thrust complete with crown billet.

Fiat 124 Abarth 1400 16v Multiair Turbo single mass flywheel kit in steel with reinforced clutch kit and ProtoXide reinforced pressure plate with copper plate disc

Lightweight single-mass steel flywheel for Ford Fiesta ST 1500 12v MK8 Turbo engine with 200hp Ecoboost engine with reinforced clutch group with COPPER plates and reinforced pressure plate for applications over 59KGM ! The usual application can also be installed on Ford Puma ST with the same engine.

exhaust manifold with ducts increased for audi volkswagen engine 2.5 TFSI with attack T3

Fiat Panda 100 HP Flywheel Kit with reinforced clutch with lightened steel flywheel with reinforced copper clutch with bell machined from solid. It can be used in all applications with Fire engines that use clutches up to a maximum of 200mm.

Lightweight single-mass steel flywheel complete with reinforced single-disc clutch with reinforced push-type pressure plate for all Alfa Giulia 2200 turbodiesel engines with manual gearbox, super-reinforced pressure plate with no wear recovery and clutch disc with reinforced springs dedicated for this application!

Mono-mass steel flywheel for all Opel Adam 1400 16v Turbo 150hp engines with organic cushioned lining clutch assembly (not copper) and ProtoXide reinforced pressure plate valid up to 300hp!

Kit Steel flywheel + copper clutch 4 plates + reinforced pressure plate Fiat Motori Fire increased diameter. Incorrect photo.

Kit composed of Alfa 147 1900 JTD ALFA GT 8-16v flywheel made of single-mass steel and clutch kit with reinforced pressure plate, special ProtoXide brake disc with copper braids in the compound, but it is still a disc not with copper plates, but a more "drivable" disc with also the anti-bend spring between the pair of linings to further increase the driveability of this specific disc with reinforced thrust springs specially made and exclusive by ProtoXide for this application.

Kit with steel flywheel Renault Clio 3 RS3 200 hp - 203hp R3 F4r830 in steel with reinforced single-disc copper clutch with Ergal bell for SADEV GEARBOX (not suitable for other applications with original gearbox), which allows you to have a super lightened clutch assembly all machined from solid, with 60-2 tone wheel for reading with sensor for original control unit and racing control units and relative crown for starter motor included.