• Online only
Single mass flywheel kit with reinforced clutch Copper 6 plates Alfa 147 - Alfa Gt 1900 JTD 8-16v Steel flywheel kit with rei...

Single mass flywheel kit with reinforced clutch Copper 6 plates Alfa 147 - Alfa Gt 1900 JTD 8-16v

€1,197.00
Tax included 2-8 giorni

Kit consists of single-mass steel flywheel and clutch kit with original reinforced pressure plate and a clutch disc with special ferode with copper braids in the compound, but it is still a disc with copper plates, but a disc more "drivabile" with the anti-bend spring between the coupling of the ferodes just to increase even more the drivability of this specific disc with reinforced thrust springs specially made and exclusive ProtoXide for this application.

Quantity
  Not available, realizable in about 5-10 days
Remember ! You find it on Protoxide Only!

Total Rating Total Rating:

0 1 2 3 4
0/5 - 0 reviews

View ratings
0 1 2 3 4 0
0 1 2 3 0 0
0 1 2 0 1 0
0 1 0 1 2 0
0 0 1 2 3 0

  Add Review View Reviews View Reviews
Pinterest
 

SECURE ENCRYPTED PAYMENTS

 

TRACKING NUMBER FOR ALL ORDERS

 

MON-FRIDAY SUPPORT 10.00-12.30 15.00-17.30

  • The kit includes a steel flywheel complete with starter sprocket, made specifically to accommodate a ProtoXide specific copper clutch plate with reinforced spring-parabolic coil specifically designed to try to reduce vibration and "loaded" in reverse. along with a reinforced original pressure plate.
  • There are known problems of dual mass flywheel breakage when increasing the stock horsepower (even just by reprogramming the ECU).
  • Specific crankshaft bolts different from the originals for this application are included.
  • The weight of the whole assembly is lightened and weighs about 16kg.
  • Installable on many JTD models including Alfa 147, Alfa GT both 8 and 16v.
  • This kit allows you to eliminate the problems present in acceleration even at low speeds, especially in higher gears, caused by the failure of the "original dual mass flywheel" thus eliminating the clutch or flywheel slippage, thanks to a reinforced pressure plate and a unique ProtoXideferode disc.
  • It is necessary to use the original thrust bearing to be purchased at the dealership as it is not included.
  • ProtoXide does not assume any responsibility due to a non-compliant choice of application for your car, although it is always possible to replace it with the correct type at no additional cost, and in any case with each order received, it will be care of one of our technicians to contact you to verify with you the correct model for your application.
  • Protoxide does not assume any responsibility for any vibration that may be created in the normal operation of the engine, due to the removal of the original dual mass flywheel, as our products are suitable only for racing vehicles where the only prerogative are the higher performance at the expense of everything else, noise, comfort and durability, especially when an application involves the use of copper material.
Name Value

Reviews Reviews (0)

Based on 0 reviews - 0 1 2 3 4 0/5