• Online only
Single mass steel flywheel kit reinforced clutch BMW Z3 1900 118hp Single mass steel flywheel kit reinforced clutch

Single-mass steel flywheel kit reinforced clutch BMW Z3 1900 118hp

kr20,608.48
Tax included 2-8 giorni

Reinforced clutch and flywheel kit BMW Z3 1900 120hp - 130hp E36 holding up to 69kgm of torque with ferodo disc, ideal for Turbo conversions!

Quantity
  Usually ships within 10-25 days
Remember ! You find it on Protoxide Only!

Add to favorites
Total Rating Total Rating:

0 1 2 3 4
0/5 - 0 reviews

View ratings
0 1 2 3 4 0
0 1 2 3 0 0
0 1 2 0 1 0
0 1 0 1 2 0
0 0 1 2 3 0

  Add Review View Reviews View Reviews
Pinterest
 

SECURE ENCRYPTED PAYMENTS

 

TRACKING NUMBER FOR ALL ORDERS

 

MON-FRIDAY SUPPORT 10.00-12.30 15.00-17.30

  • Single mass steel flywheel kit with reinforced clutch BMW Z3 1900 8v- 16v
  • There are known problems with the dual mass flywheel breaking when increasing the standard horsepower (even just by reprogramming the ECU) or the clutch slipping after remapping the ECU or adding a modified turbocharger. Kit with a special single-mass steel flywheel made to accommodate a specific disk created for turbodiesels with double shock absorbers
  • This kit comes with: steel flywheel, super reinforced PERFORMANCES 69KGM clutch pressure plate designed as a unique exclusive ProtoXide solution that takes the place of the original non-reinforceable clutch pressure plate with wear recovery, and relative clutch disc
  • in special ProtoXide copper.
  • The starter motor crown is to be recovered from your flywheel.
  • High tensile bolts for fixing on crankshaft, included in the package, specific for this application
  • The weight of the whole assembly is approximately kg.
  • This kit allows you to eliminate problems present in acceleration even at low revs, especially in higher gears, caused by the failure of the "original dual mass flywheel" thus eliminating clutch or flywheel slippage, thanks to a reinforced clutch pressure plate and a unique and unobtainable ProtoXide ferodo disc.
  • It is necessary to use the original thrust bearing which can be purchased from the dealer as it is not included.
  • ProtoXide assumes no responsibility due to a non-compliant choice of application for your vehicle, even if it is always possible to replace it with the correct type without further costs, and in any case for each order received, one of our technicians will contact you to verify together with you the correct model for your application.
  • Protoxide assumes no responsibility for any vibrations that may be created during normal engine operation, due to the removal of the original dual-mass flywheel, as our products are only suitable for racing vehicles where the only prerogative is greater performance to the detriment of everything else, noise, comfort and durability (especially when an application involves the use of copper material).
Name Value

Reviews Reviews (0)

Write a Review
Based on 0 reviews - 0 1 2 3 4 0/5

In the same category