• Online only
  • -€40.00
  • New
  • Save €40.00
Reinforced Single Mass Flywheel Kit Alfa Romeo Giulietta 1600 -120hp 940C1000 Reinforced Clutch Steel Flywheel Kit

Reinforced Single Mass Flywheel Kit Alfa Romeo Giulietta 1600 -120hp 940C1000

€1,489.00
€1,449.00 Save €40.00
Tax included 2-8 giorni

Single mass flywheel and reinforced clutch kit Alfa Romeo Giulietta 1600 -120hp can be installed on all versions with 1600 engine with 940C1000 engine type manual gearbox. The kit includes the specific high traction flywheel bolts and the original thrust bearing must be sent to us to be modified

Quantity
  Not available. Made in 2-3 months
Remember ! You find it on Protoxide Only!

Add to favorites
Total Rating Total Rating:

0 1 2 3 4
0/5 - 0 reviews

View ratings
0 1 2 3 4 0
0 1 2 3 0 0
0 1 2 0 1 0
0 1 0 1 2 0
0 0 1 2 3 0

  Add Review View Reviews View Reviews
Pinterest
 

SECURE ENCRYPTED PAYMENTS

 

TRACKING NUMBER FOR ALL ORDERS

 

MON-FRIDAY SUPPORT 10.00-12.30 15.00-17.30

  • Flywheel kit with single mass in steel and reinforced clutch Alfa Romeo Giulietta 1600 -120hp 940C1000 capable of supporting up to 59kgm of torque installable on engines with engine code 940C1000
  • This kit comes with: steel flywheel, super reinforced pressure plate and reverse loaded clutch with anti-roll bar and new set of screws specific for this application.
  • There are known problems with the dual mass flywheel breaking when increasing the standard horsepower (even just by reprogramming the ECU) or the clutch slipping even just after remapping the ECU or adding a modified turbocharger. Many of you contact us because they have already changed several reinforced clutches and continue to burn them, but for us there is nothing strange for this engine as for many others our kit is the only one to maintain up to 59kgm of torque.
  • Steel flywheel complete with starter motor crown complete with special ferodo disc with copper inside the mix but it is not a disc with ProtoXide copper plates
  • Specific American high tensile bolts for fixing on crankshaft, included in the package, specific for this application.
  • Unique kit made and developed entirely and EXCLUSIVELY in ProtoXide.
  • This kit eliminates problems present in acceleration at low revs, especially in higher gears, caused by the clutch slipping with the flywheel, thanks to a reinforced clutch pressure plate and a ferodo disc.
  • ProtoXide assumes no responsibility due to a non-compliant choice of application for your vehicle, even if it is always possible to replace it with the correct type without further costs, and in any case for each order received, one of our technicians will contact you to verify together with you the correct model for your application.
  • Protoxide assumes no responsibility for any vibrations that may be created during normal engine operation, due to the removal of the original dual-mass flywheel, as our products are only suitable for racing vehicles where the only prerogative is greater performance to the detriment of everything else, noise, comfort and durability (especially when an application involves the use of copper material).
Name Value

Reviews Reviews (0)

Write a Review
Based on 0 reviews - 0 1 2 3 4 0/5

In the same category