Aluminum clutch flywheel kit, copper plates and reinforced pressure plate for Fiat Punto GT

Single-mass steel flywheel kit reinforced clutch Alfa Romeo Giulietta 1750 Tbi with special ferodo disc and special reinforced pressure plate complete with dedicated screws. Choose the two versions based on the torque to be supported and consequently the force to be applied to the clutch pedal will also change a little depending on the version purchased.

Single-mass steel flywheel for all Fiat 500 0.9 105 TwinAir turbo engines and cars with organic brake clutch assembly (not copper) and ProtoXide reinforced pressure plate. Can be installed on all 5-6 speed manual gearboxes.

Single-mass flywheel kit with reinforced clutch Citroen C6, Peugeot 206 1.6 Hdi 110hp in with reinforced clutch and flywheel designed to accommodate a specific disc with thrust springs.

Kit with single-mass flywheel in ProtoXide competition steel complete with reinforced Sasch Performance pressure plate and brake lining disc

Single-mass steel flywheel with reinforced clutch for all Ford Focus 2500 engines with double crown for rpm sensor and Turbo starter engine code hp with reinforced clutch assembly in ferodo and reinforced pressure plate without wear recovery for applications up to and beyond 400hp.

Steel flywheel kit with reinforced single-disc copper clutch with bell machined from solid ergal, all lightened complete with starter crown. Super lightened flywheel with copper clutch with Ergal light alloy pressure plate.

Single-mass steel flywheel kit lightened with reinforced clutch to be replaced identically with the standard one, with crown for revolution sensor for Renault Clio 3000 V6 Maxi with reinforced clutch with usual wear recovery system equal to the original standard clutch. Unique Protoxide design unobtainable made in this type of clutch. Clutch kit with single-mass flywheel that can be installed on both Renault Clio V6 versions on both phase 1 and phase 2.

Kit with flywheel in super lightened steel with reinforced clutch in copper with bell machined from solid, with phonic wheel 60-2 for reading with sensor for original control unit and competition control units.

Kit with flywheel special steel mono-mass produced to accommodate a specific disk with thrust springs, together with a pressure plate reinforced.

Single mass flywheel kit with reinforced clutch with special brake disc with cushioned flexible coupling and specific reinforced pressure plate Audi S3 225hp - 210 hp Turbo 1800 20v or similar Volkswagen and Seat engines.