Transparent red military type switch baby go

Spare control unit with double remote control already programmed for use on exhaust valves.

12 volt timed relay can activate or deactivate any electronic component with a timer that can be set from 0.5 seconds up to 60 hours!

Pull switch, very convenient to turn anything on or off.

Circuit built and programmed according to your needs up to 2 relays.

Military type switch with safety protection, yellow colour.
Suitable for any use, notable aesthetic impact.

Pull switch, very convenient to activate something.

24v relay which, through a very fast impulse with negative or positive command, can activate and keep activated a load of up to 20 amps and then always turn it off with the usual impulse of a few milliseconds, and so on. To be used in direct current DC.

This control unit allows to set a threshold from 0-5 volts that when exceeding a selected voltage activates a relay such as the prot oxide relay or any other activation

Enable or disable up to 4 relays from a 12 volt supply with the simple press of one of the 4 buttons on your remote. Normally used to open or close exhaust throttles, change maps, or toggle something on/off, screw terminals

With this relay you can simply by using a very fast pulse with negative or positive command, activate and hold a load up to 20amp and then always turn it off with the usual pulse of a few milliseconds, and so on. 814

Switch with red LED integrated.

Normally open red button with fixing ring and two screwed poles.

Battery cut-off switch with deactivatable key

With newly built 12 volt relays you can simply use a very fast impulse with a negative or positive command to activate and keep a load of up to 20amp activated and then always turn it off with the usual impulse of a few milliseconds, and so on. To be used in direct current DC.

It is found in multiple uses from control units for competition on cars or on industrial vehicles such as excavators 01170716 and agricultural vehicles and nautical applications.

Activate mapping 1 or mapping 2 directly with a simple push of a button on the remote control. An easy way to avoid having to install visible buttons only for all Unichip ECUs, any model and many other ECUs.